2022-2025 Lucid Air Frunk Storage Bin: Inspection and Replacement Guide
This guide covers the front trunk (frunk) storage bin, clarifying its part number and providing tips for inspecting a used replacement.
- This part (P11-E75700-03) is the storage tub for the front trunk (frunk), not the rear trunk.
- Failure is always physical damage like cracks or warping; there are no electronic symptoms or recalls for this part.
- When buying used, carefully inspect for hairline cracks and ensure the bin is not warped by checking it on a flat surface.
- Replacement is a very simple DIY task that requires no special tools and can be completed in under 30 minutes.
Part Identification: Front Trunk (Frunk) vs. Rear Trunk
It is important to note that the OEM part numbers P11-E75700-03 and P11E75700 refer specifically to the main storage tub located in the front trunk (frunk) of the 2022-2025 Lucid Air. This part should not be confused with the lower storage area in the rear trunk, which is a separate component. When searching for or ordering this part, ensure you are looking for the 'frunk storage tub' or 'front compartment trim'.
Symptoms of a Damaged Frunk Storage Bin
As a simple molded plastic part, failure is always due to physical damage rather than mechanical or electrical issues. There are no associated fault codes or electronic symptoms.
- Visible Cracks or Fractures: The most common failure is cracking, often caused by dropping heavy or sharp objects into the bin. Hairline cracks can worsen over time due to vibration and temperature changes.
- Warping or Deformation: Extreme heat or improper storage when removed from the vehicle can cause the bin to warp, leading to a poor fit and potential rattling.
- Broken Mounting Points: If the bin uses any clips, tabs, or screw holes to secure it, damage to these points can cause it to become loose.
- Rattling Noises: A loose, cracked, or poorly fitting bin may rattle or creak as the vehicle moves, especially over bumps.
Pro Tip: While the bin itself is not electronic, some owners have reported issues with the frunk's electronic latching and closing mechanisms. If you are experiencing problems with the frunk opening or closing, the issue is likely with the latch or control software, not the plastic bin itself.
Buying a Used Frunk Storage Bin: What to Check
For a part like this, a used OEM bin is an excellent value, offering the same fit and durability as a new part for a fraction of the price. Aftermarket copies are generally not available for this specific component. Pay close attention to the following during inspection:
- Inspect for Cracks: Carefully examine the entire bin, especially the corners, floor, and any sharp angles where stress concentrates. Flex the plastic slightly to reveal any hidden hairline cracks.
- Check for Warping: Place the bin on a large, flat surface. It should sit flush without any significant rocking or gaps. A warped bin will not install correctly and may cause persistent rattles.
- Verify All Mounting Tabs: If the bin has integrated clips or screw holes, confirm they are all present and free of cracks or stress marks. A single broken mounting point can compromise the fit.
- Confirm the Part Number: Match the part number (P11-E75700-03 or P11E75700) to ensure you are getting the correct component for your vehicle.
Cost Comparison
Pricing for the Lucid Air frunk storage bin can vary significantly between new and used options.
| Part Source | Estimated Price Range |
|---|---|
| New OEM (Dealer) | Contact dealer for pricing |
| New Aftermarket | Not Available |
| Used OEM | $150 - $300 |
| Shop Labor | $40 - $80 |
Replacement Guide
Replacing the frunk storage bin is a straightforward task suitable for any DIY skill level.
- Difficulty: 1 out of 5
- Estimated Time: 15 minutes
- Tools Required: Basic trim removal tools or a flathead screwdriver may be needed if any clips are present.
Step-by-Step Replacement
- Open the frunk and remove any personal items.
- Remove the main frunk floor panel or carpet. This typically lifts straight out.
- Visually inspect the perimeter of the storage bin for any fasteners like push-pins or screws. If any are found, remove them.
- Carefully lift the old storage bin straight up and out of the frunk cavity.
- Clean the area underneath the bin before installing the new one.
- Set the new bin in place, ensuring it sits flush and is properly seated.
- Re-install any fasteners that were removed.
- Replace the frunk floor panel.
Recalls and Technical Service Bulletins (TSBs)
As of mid-2026, there are no specific recalls or TSBs from Lucid Motors or the NHTSA related to the physical frunk storage bin for the 2022-2025 Lucid Air. Recalls for this vehicle pertain to software, electrical components like inverters, and wiring harnesses.
Frequently Asked Questions (FAQ)
Is part number P11-E75700-03 for the front or rear trunk?
This part number is for the storage bin located in the front trunk, also known as the frunk.
Can a cracked frunk bin be repaired?
While plastic repair kits exist, they are often not a permanent solution for a large, flexible part like this. The repair may not be cosmetically appealing and could fail again. Replacement with a good-condition used part is the recommended solution.
Do I need special tools to replace the frunk bin?
No special tools are required. The bin is designed to be easily removed. You may need a simple trim removal tool to release any retaining clips without scratching the surrounding plastic, but in many cases, no tools are needed at all.
Will a damaged frunk bin cause any warning lights?
No. The bin is a simple piece of plastic with no sensors or electrical connections. A damaged bin will not trigger any warnings on the dashboard.
Technical Specifications
OEM Part Numbers: P11-E75700-03 P11E75700
Material: Molded ABS Plastic Location: Front Trunk (Frunk)
We Have This Part in Stock
The information in this article is provided for general reference and educational purposes only. Vehicle specifications, procedures, and part compatibility can vary by production date, trim level, and region. Always consult your vehicle's factory service manual and verify part numbers before purchasing or performing repairs. Safety-critical components such as airbags, seat belts, and braking systems should be installed by a qualified professional.
- Lucid Air:
- 🛍️ Shop This Part
- Part Identification: Front Trunk (Frunk) vs. Rear Trunk
- Symptoms of a Damaged Frunk Storage Bin
- Buying a Used Frunk Storage Bin: What to Check
- Cost Comparison
- Replacement Guide
- Step-by-Step Replacement
- Recalls and Technical Service Bulletins (TSBs)
- Frequently Asked Questions (FAQ)
- 🎟️ Get 5% Off