2021-2024 Genesis G80 Tail Finish Panel: Stained Chrome TSB and Sport vs. Base Trim Guide
This guide covers the critical differences between Sport and Base model tail finish panels and details a known issue with discolored dark chrome trim.
- Verify your trim before buying: The G80 uses different panels for Base (bright chrome, #87380-T1000) and Sport (dark chrome, #87380-T1010) models.
- Check for stained chrome: A Genesis TSB (#25-BD-001G) addresses discoloration on the dark chrome trim of Sport models; inspect any used part for this defect.
- Match the paint code: Panels are painted. Find the code on your driver's door jamb sticker to avoid repainting costs.
- Inspect used parts for intact mounting tabs and signs of water intrusion before purchasing.
Key Differences: Sport Package vs. Base Model
The most important factor when replacing the tail finish panel on a 2021-2024 Genesis G80 is identifying your vehicle's trim. Genesis uses different panels for the standard (Base) and Sport Package models, and they are not interchangeable. The primary difference is the finish of the chrome accent strip that runs the length of the panel.
- Base Model Panel (Part # 87380-T1000): This panel typically features a bright chrome finish on the accent trim.
- Sport Package Panel (Part # 87380-T1010): This panel uses a 'Dark Chrome' or tinted chrome finish for a more aggressive look.
Warning: Always verify the part number you need before ordering. Installing a Sport panel on a Base model (or vice-versa) will result in a mismatched trim finish with other chrome elements on the vehicle.
Known Issues & TSBs for 2021-2024 Genesis G80
TSB: Stained or Discolored Dark Chrome Trim
Genesis issued Technical Service Bulletin (TSB) #25-BD-001G for several models, including the 2021+ G80, concerning stained or discolored dark chrome trim. This issue is particularly relevant to the tail finish panel on Sport Package models.
- Symptom: The dark chrome trim develops stains, spots, or discoloration.
- Cause: The bulletin states that stains can occur from hard water or certain cleaning chemicals used during car washes.
- Solution: The TSB instructs dealerships to replace the affected dark chrome trim pieces under warranty. The previous procedure of trying to clean the trim was superseded by full replacement.
When inspecting a used G80 or a recycled tail finish panel, pay close attention to the condition of the dark chrome trim for this specific issue.
Common Symptoms of Failure
Failures of the tail finish panel are typically related to physical damage, electrical issues, or cosmetic degradation.
- Cracks or Scratches: The most common failure is physical damage from a rear-end collision or impact. This can range from minor scuffs to large cracks that compromise the integrity of the panel and allow water to enter.
- Flickering or Dead Lights: If the integrated LED lighting within the panel fails, it may flicker or go out completely. This can be caused by a failure in the LED strip itself, a loose connection, or corrosion in the electrical socket from moisture intrusion.
- Rear Camera or Trunk Release Malfunction: Since the panel houses the rear-view camera and trunk release button, damage to the panel can sever wiring or damage these components, causing them to fail.
- Moisture Inside Panel: A bad seal or a small crack can allow water to get inside the panel or light housing. This can cause condensation to appear, which can lead to short circuits and corrosion over time.
Buying a Used Tail Finish Panel
A used OEM tail finish panel is an excellent alternative to a costly new part, especially since aftermarket options are virtually nonexistent for this model. However, careful inspection is critical.
Inspection Checklist:
- Verify the Part Number: This is the most important step. Check if you need the Base (87380-T1000) or Sport (87380-T1010) version. Do not rely on visual appearance alone.
- Inspect the Chrome Trim: Look for the staining and discoloration issue described in TSB #25-BD-001G, especially on Sport panels. Check for peeling or pitting.
- Check for Cracks: Examine the entire surface, especially around mounting points and corners, for hairline cracks. Flex the panel slightly to reveal hidden damage.
- Confirm All Mounting Tabs are Intact: Turn the panel over and inspect every mounting tab and clip location. Broken tabs will prevent the panel from sitting flush against the trunk lid and can lead to rattles and water leaks.
- Look for Signs of Water Intrusion: Check for a 'water line' or mineral deposits inside the clear lens areas. This indicates a bad seal.
- Match Your Paint Code: These panels are color-matched to the vehicle. You must find a used panel from a vehicle with the same paint code to avoid the cost of repainting. The paint code is found on the vehicle's VIN sticker, located on the driver's side door jamb.
Replacement Overview
Replacing the tail finish panel is a manageable DIY job for those comfortable with basic tools and trim removal. The process involves removing the trunk lid's interior trim to access the panel's mounting hardware.
- Difficulty: 2/5
- Estimated Time: 1 hour
- Tools Needed: Trim removal tool, socket set (likely 8mm or 10mm), Phillips screwdriver.
Step-by-Step Guide:
- Open the Trunk: Ensure the trunk is open and securely propped.
- Remove Trunk Lid Liner: Using a trim removal tool, carefully pry out the plastic clips holding the carpeted liner to the inside of the trunk lid. There may also be screws inside the trunk grab handle that need to be removed.
- Disconnect Electrical Connectors: With the liner removed, locate the wiring harnesses for the taillights, trunk release button, and rear-view camera. Carefully disconnect each electrical connector.
- Unbolt the Tail Finish Panel: The panel is secured by several nuts (likely 10mm) on the inside of the trunk lid. Remove all of them.
- Remove the Old Panel: With the nuts and electrical connectors removed, the panel should come free from the outside of the trunk lid. You may need to gently push it from the inside. Be careful not to scratch the vehicle's paint.
- Install the New Panel: Position the new panel, ensuring all mounting studs go through their corresponding holes. Hand-tighten the nuts from the inside, then reconnect all electrical harnesses.
- Test Functionality: Before reinstalling the trunk liner, test the lights, trunk release, and camera to ensure everything works correctly.
- Reinstall Trunk Lid Liner: Secure the liner with its clips and any screws you removed.
Pro Tip: When buying a used panel, ask the seller to include the mounting nuts and any associated wiring pigtails. This can save you a trip to the dealership if you lose or break a piece of hardware.
Cost Comparison
Replacing a damaged tail finish panel can be expensive, especially when buying new from a dealership. A used OEM part offers significant savings.
| Part Type | Estimated Cost |
|---|---|
| New OEM | $530 - $850 |
| New Aftermarket | Not Generally Available |
| Used OEM | $150 - $350 |
| Shop Labor | $100 - $200 |
Frequently Asked Questions
Can I install a Sport Package finish panel on my Base G80?
Physically, it may bolt on, but the dark chrome finish will not match the bright chrome on the rest of your car's trim, such as the window surrounds. For a correct appearance, you must use the panel that matches your car's original trim package.
How do I find my G80's paint code?
Your Genesis paint code is located on the manufacturer's sticker in the driver's side door jamb. Look for the 'PAINT' heading; the code is typically two or three characters long.
My dark chrome trim is stained. What should I do?
If your vehicle is still under warranty, contact a Genesis dealership and reference TSB #25-BD-001G. The service bulletin advises replacing the stained trim. Do not use harsh chemicals or abrasives to try and clean it, as this can make the problem worse.
Is the rear-view camera included with a replacement panel?
It depends on the seller. New OEM panels typically do not include the camera or trunk release switch, which must be purchased separately or transferred from your old panel. When buying used, confirm with the seller whether these components are included.
Technical Specifications
OEM Part Numbers: 87380-T1000 87380-T1010 87370-T1000 87370-T1030 87380-T1030
Material: Plastic composite with integrated LED lighting. Finish: Body-colored paint with either bright chrome (Base) or dark chrome (Sport) accents.
The information in this article is provided for general reference and educational purposes only. Vehicle specifications, procedures, and part compatibility can vary by production date, trim level, and region. Always consult your vehicle's factory service manual and verify part numbers before purchasing or performing repairs. Safety-critical components such as airbags, seat belts, and braking systems should be installed by a qualified professional.
- Genesis G80:
- Key Differences: Sport Package vs. Base Model
- Known Issues & TSBs for 2021-2024 Genesis G80
- TSB: Stained or Discolored Dark Chrome Trim
- Common Symptoms of Failure
- Buying a Used Tail Finish Panel
- Inspection Checklist:
- Replacement Overview
- Step-by-Step Guide:
- Cost Comparison
- Frequently Asked Questions
- 🎟️ Get 5% Off