2013-2014 Dodge Viper Interior Rear View Mirror: Stains, Part Numbers, and Replacement
This guide covers the common failures, updated part numbers, and replacement process for the high-tech interior rear view mirror in the Gen 5 Dodge Viper.
- The most common failure is internal staining or 'desilvering' of the glass, which requires complete replacement.
- The current OEM part number is 68141142AC, which supersedes older AA and AB versions. Always try to buy the 'AC' version.
- A new mirror from Mopar is very expensive (over $770), making a quality used part a smart financial choice.
- Replacement is a simple DIY job, typically requiring only a Torx driver and careful handling.
Symptoms of a Failing Viper Rear View Mirror
When the complex electronics inside the Viper's mirror begin to fail, you may notice several distinct symptoms. Understanding these signs can help you determine if you need a replacement.
Internal Stains or Bubbles
The most common and definitive sign of failure for the Gen 5 Viper mirror is the appearance of stains, bubbles, or a clear line that looks like it's inside the glass. This is often called 'desilvering' and occurs when the seal around the internal electrochromic gel fails, allowing it to degrade. The stain may have a brownish or yellowish tint and will not come off with cleaning, as the damage is internal. Owners report that this issue often starts small and gets progressively worse over time. This is a permanent failure, and the only solution is to replace the mirror assembly.
Auto-Dimming Malfunction
You might notice that the mirror no longer dims when bright headlights are behind you, or it dims erratically. This can be caused by a few issues. First, check that the light sensors on the front and back of the mirror are clean and unobstructed. If cleaning the sensors doesn't solve the problem, the internal electronics or the sensors themselves have likely failed.
Leaking Fluid
In severe cases of electrochromic failure, the gel inside the mirror can leak out. This substance is often described as oily and can be toxic. If it drips onto the dashboard or center console, it can cause permanent damage to the plastic or leather surfaces. If you see any fluid leaking from the mirror housing, it must be replaced immediately.
Dead Buttons or No Power
If the Assist and 911 buttons stop working, or if the auto-dimming feature is completely dead, the mirror may have lost power. The first step is to check the fuse associated with the mirror and interior lighting. If the fuse is good, there may be an issue with the wiring harness or the electrical connector behind the mirror.
Known Issues, TSBs, and Recalls
As of mid-2026, there are no specific recalls or Technical Service Bulletins (TSBs) from Dodge or the NHTSA that directly address failures of the interior rear view mirror for the 2013-2014 Dodge Viper.
However, these vehicles were subject to other recalls, including one for a radio software vulnerability (NHTSA Campaign Number: 15V461000) and another for a potential issue with door latch switches (NHTSA Campaign Number: 15V201000). It is always a good practice to check if these recalls have been performed on your vehicle.
Part Variants and Supersessions
Understanding the part numbers is key to buying the correct mirror. Mopar has released several versions of this part, with newer numbers superseding older ones.
| Part Number | Status | Notes |
|---|---|---|
| 68141142AA | Superseded | Original part number. |
| 68141142AB | Superseded | First revision. Replaced by the 'AC' version. |
| 68141142AC | Current | This is the latest, most updated version of the mirror. It replaces both the AA and AB versions and is the recommended part for replacement. |
All versions of this mirror for the 2013-2014 Viper include the auto-dimming feature and the Assist/911 buttons. There are no known 'base model' mirrors without these features for this vehicle.
Pro Tip: When searching for a used part, prioritize finding the newest 68141142AC version, as it likely contains internal improvements over the older AA and AB versions.
Buying a Used 2013-2014 Viper Rear View Mirror
Given the extremely high cost of a new OEM mirror, a used unit is an excellent value. However, you must inspect it carefully to avoid buying a part that is already failing.
- Inspect the Glass Thoroughly: Look for any signs of the internal staining, discoloration, or bubble-like patterns mentioned earlier. Hold the mirror up to a light and view it from multiple angles. This is the most common failure, so be meticulous.
- Check for Leaks: Examine the seams of the mirror housing for any oily residue, which would indicate a leak of the electrochromic fluid.
- Verify the Buttons: Ensure the Assist and 911 buttons are physically intact, not cracked, and have a solid feel when pressed.
- Examine the Mounting Point: Check the plastic housing and the metal mounting point on the back for any cracks or stress marks. A damaged mount can cause vibrations or prevent the mirror from seating securely.
- Match the Part Number: Whenever possible, get the 68141142AC part number. While the AA and AB versions will fit, the AC is the most current design.
Replacement Guide
Replacing the interior rear view mirror is a straightforward task that most DIY mechanics can complete in under 30 minutes. However, care must be taken to avoid damaging the windshield or the part itself.
Warning: Some owners have noted that removing the mirror can be tricky and may feel like you are applying excessive force. Proceed slowly and patiently to avoid breaking the mirror mount or the windshield.
- Disconnect the Electrical Connector: Carefully pry down any plastic cover at the base of the mirror where it meets the headliner. This should expose the wiring harness. Depress the tab on the connector and pull it apart.
- Loosen the Set Screw: Look at the bottom of the mirror's mounting arm. You should find a small Torx screw (often a T20 size). Loosen this screw a few turns. You do not need to remove it completely.
- Slide the Mirror Off: With the screw loosened, firmly grip the mirror assembly and slide it straight up, parallel to the windshield, to disengage it from the metal button that is glued to the glass. Do not pull it straight back towards you.
- Install the New Mirror: Installation is the reverse of removal. Slide the replacement mirror down onto the windshield button until it's fully seated. Tighten the Torx set screw until snug—do not overtighten. Reconnect the electrical harness and snap the plastic cover back into place.
Cost Comparison
| Part Type | Estimated Cost |
|---|---|
| New OEM (Mopar) | $770 - $1,190 |
| New Aftermarket | Not Available |
| Used OEM | $250 - $450 |
| Shop Labor | $50 - $100 |
Frequently Asked Questions (FAQ)
What is the difference between part numbers 68141142AA, AB, and AC?
These are revision numbers. 68141142AC is the newest version and supersedes, or replaces, the older AA and AB parts. It is always best to install the latest version available, as it may contain design or material improvements to address known issues.
My mirror has a weird stain inside the glass. Can it be repaired?
No, this internal staining or 'desilvering' is a sign that the electrochromic gel inside the mirror has failed. This damage is not repairable, and the entire mirror assembly must be replaced.
Does the new mirror need to be programmed to the car?
No, the interior rear view mirror does not require any special programming or calibration after installation. It is a plug-and-play component. The Assist/911 functions are tied to your vehicle's telematics subscription and should work automatically with the new mirror.
Is the fluid that leaks from a broken auto-dimming mirror dangerous?
Yes, the fluid inside an electrochromic mirror is considered toxic and can be corrosive. It can stain and damage plastic and leather surfaces inside your car. If your mirror is leaking, avoid touching the fluid and replace the mirror as soon as possible.
Technical Specifications
OEM Part Numbers: 68141142AA 68141142AB 68141142AC
Features: Auto-dimming (electrochromic), integrated Assist/911 buttons.
The information in this article is provided for general reference and educational purposes only. Vehicle specifications, procedures, and part compatibility can vary by production date, trim level, and region. Always consult your vehicle's factory service manual and verify part numbers before purchasing or performing repairs. Safety-critical components such as airbags, seat belts, and braking systems should be installed by a qualified professional.
- Dodge Viper:
- Symptoms of a Failing Viper Rear View Mirror
- Internal Stains or Bubbles
- Auto-Dimming Malfunction
- Leaking Fluid
- Dead Buttons or No Power
- Known Issues, TSBs, and Recalls
- Part Variants and Supersessions
- Buying a Used 2013-2014 Viper Rear View Mirror
- Replacement Guide
- Cost Comparison
- Frequently Asked Questions (FAQ)
- 🎟️ Get 5% Off