2017-2018 INFINITI Q60 Grille Emblem: Standard vs. Adaptive Cruise Control Versions
This guide explains the critical differences between the standard grille emblem and the version for vehicles with adaptive cruise control to ensure you buy the correct part.
- The most critical factor is vehicle options: Part 62890-5CA0A is ONLY for models WITHOUT adaptive cruise control.
- Using the wrong emblem on a car with ACC will disable safety features like Forward Emergency Braking.
- Failure of the standard emblem is purely cosmetic; it will not cause warning lights.
- When buying used, ensure all mounting tabs on the back are intact, as this is how it secures to the grille.
Symptoms of a Failing Grille Emblem
For the standard emblem (part 62890-5CA0A), failure is entirely cosmetic. Since it has no electronic function, you will not see any warning lights or receive diagnostic trouble codes. Symptoms are limited to what you can see:
- Physical Damage: Cracks, chips, or pieces breaking off, usually from road debris or minor impacts.
- Cosmetic Blemishes: The chrome finish can peel, fade, or develop a hazy or cloudy appearance over time due to sun exposure and weather.
Important: If your Q60 has Adaptive Cruise Control (ACC) and the emblem is damaged, you may see warning lights like "Forward Emergency Braking (FEB) Unavailable" or have issues with the cruise control system. This is because the damaged emblem can interfere with the radar sensor behind it. The part covered in this guide, 62890-5CA0A, is NOT for vehicles with these features.
Known Issues, TSBs, and Recalls
As of this writing, there are no recalls or Technical Service Bulletins (TSBs) issued by INFINITI or the National Highway Traffic Safety Administration (NHTSA) specifically for the grille emblem on the 2017-2018 Q60. Any issues with the emblem are typically related to cosmetic wear or physical damage.
A recall (NHTSA Campaign #17V476000) was issued for some 2017 Q60 models related to the fuel pump control module software, which could cause the engine to stall, but this is unrelated to the grille emblem.
Buying a Used 2017-2018 Q60 Grille Emblem
Buying a used OEM emblem is a great way to save money, but careful inspection is key. The most critical step is verifying which version your vehicle needs.
How to Check for Adaptive Cruise Control (ACC)
Before you buy, determine if your Q60 has the technology package, which includes Intelligent Cruise Control (ICC) and other driver-assist features.
- Steering Wheel Buttons: Look at the right side of your steering wheel. If you have buttons with icons of a car with radar waves coming from it, you have ACC.
- Emblem Appearance: The standard emblem has a three-dimensional, chrome-sculpted look. The emblem for ACC models is flat, smooth, and sits inside a defined rectangular housing to allow the radar waves to pass through.
- Vehicle Information Display: When you start the car, the vehicle information display may show icons related to the driver assistance systems if equipped. 🎬 Watch: How to identify and use Infiniti's Intelligent Cruise Control
What to Inspect on a Used Emblem
- Part Number Verification: The standard emblem for vehicles without ACC is part number 62890-5CA0A. The emblem for vehicles with ACC is part number 62890-5CB0A. Do not interchange them.
- Mounting Tabs: Carefully inspect the back of the emblem. All mounting tabs and clips must be intact. If any are broken, the emblem will not sit securely in the grille and may fall out.
- Cosmetic Condition: Check for deep scratches, peeling chrome, or significant hazing. Minor scuffs may be acceptable, but major cosmetic flaws defeat the purpose of replacing a damaged emblem.
- No Cracks: Even small cracks can allow moisture to get behind the chrome finish, causing it to peel or bubble over time.
Pro Tip: Some Q60 models came with an optional illuminated emblem. This is a separate part (like F2310-5CA0K) and has different wiring and fitment requirements. The standard emblem cannot be easily modified to light up.
Cost Comparison (2017-2018 Q60 Grille Emblem)
Prices can vary based on supplier and condition. The following is an estimated breakdown:
| Part Type | Estimated Price Range |
|---|---|
| New OEM (Standard, 62890-5CA0A) | $90 - $150 |
| New OEM (With ACC, 62890-5CB0A) | $150 - $250+ |
| Used OEM (Standard) | $50 - $100 |
| Aftermarket (Illuminated/Custom) | $150 - $700+ |
| Shop Labor for Installation | $75 - $150 |
Installation Guide
Difficulty: 2 out of 5
Replacing the grille emblem is generally straightforward but may require removing the upper radiator cover or grille assembly for access. The emblem itself is typically held in by clips or tabs from the back.
Steps:
- Open the Hood: Secure the hood in the open position.
- Remove Radiator Cover: Remove the plastic clips or push-pins holding the upper radiator sight shield (the plastic panel above the grille). This will give you access to the top of the grille assembly.
- Access the Emblem: Reach behind the grille to locate the back of the emblem. You may need to use a trim removal tool to gently release the locking tabs.
- Remove Old Emblem: Carefully push the emblem out from the back while ensuring all tabs have been released. Do not pry from the front, as this can damage the grille.
- Install New Emblem: Clean the mounting area on the grille. Align the tabs on the new emblem with the slots in the grille and press it firmly into place until it clicks and is secure.
- Reassemble: Reinstall the radiator cover and any other components you removed.
Frequently Asked Questions (FAQ)
Can I install an illuminated aftermarket emblem on my Q60?
Yes, but with limitations. If your vehicle has the technology package with the forward radar sensor, you generally cannot use an illuminated emblem, as it will interfere with the sensor. If you have a base model without the sensor, several aftermarket illuminated emblems are available, but they will require tapping into a power source like the headlights.
Why can't I use the standard emblem on my car with adaptive cruise control?
The standard, three-dimensional chrome emblem (62890-5CA0A) is made of materials that will block or deflect the radar waves from the Intelligent Cruise Control sensor. This will disable the system and likely trigger warning lights on your dash. You must use the correct flat-surfaced emblem (62890-5CB0A) designed to be transparent to radar signals.
Is the grille emblem held on with adhesive?
No, for the 2017-2018 Q60, the front grille emblem is secured with mounting tabs and clips from behind the grille. It is not attached with double-sided tape. The trunk emblem, however, typically uses adhesive.
Does a used emblem need to be reprogrammed?
No. The emblem itself contains no electronics and requires no programming. However, if you are replacing the actual radar sensor unit behind the emblem, that component may require calibration by an Infiniti dealer or qualified shop.
Helpful Videos
Technical Specifications
OEM Part Numbers: 62890-5CA0A (Without Adaptive Cruise Control) 62890-5CB0A (With Adaptive Cruise Control) F2310-5CA0K (Optional Illuminated Emblem)
N/A
We Have This Part in Stock
The information in this article is provided for general reference and educational purposes only. Vehicle specifications, procedures, and part compatibility can vary by production date, trim level, and region. Always consult your vehicle's factory service manual and verify part numbers before purchasing or performing repairs. Safety-critical components such as airbags, seat belts, and braking systems should be installed by a qualified professional.
- INFINITI Q60:
- 🎬 Helpful Videos
- 🛍️ Shop This Part
- Symptoms of a Failing Grille Emblem
- Known Issues, TSBs, and Recalls
- Buying a Used 2017-2018 Q60 Grille Emblem
- How to Check for Adaptive Cruise Control (ACC)
- What to Inspect on a Used Emblem
- Cost Comparison (2017-2018 Q60 Grille Emblem)
- Installation Guide
- Difficulty: 2 out of 5
- Steps:
- Frequently Asked Questions (FAQ)
- 🎟️ Get 5% Off