2022-2025 Lucid Air Driver's Dash End Cap: Avoiding Rattles and Matching Interior Trim
This small but critical trim piece finishes the dashboard's appearance, helps prevent rattles, and must be carefully inspected before buying used.
- When buying a used end cap, always get photos of the back to ensure all mounting clips are intact and undamaged.
- You must match the part to your Lucid Air's specific interior trim package (e.g., Santa Cruz, Tahoe) to ensure the color and finish are correct.
- This part is held in by clips and can be replaced in minutes with only a plastic pry tool, making it a very easy DIY job.
- A loose or broken end cap is a likely source of rattles or buzzing noises coming from the driver's side of the dashboard.
Symptoms of a Bad or Damaged Dashboard End Cap
As a non-mechanical trim piece, the dashboard end cap doesn't "fail" in a traditional sense. Instead, problems are related to physical damage or improper fitment.
- Visible Cosmetic Damage: This is the most common issue. Look for deep scratches, scuffs, or gouges, often caused by contact with keys, bags, or during vehicle service. The panel may also show discoloration or fading from prolonged sun exposure.
- Rattling or Buzzing Noises: If the end cap's mounting clips are broken or it has been removed and not reinstalled correctly, it can vibrate against the dashboard or A-pillar. In a vehicle as quiet as the Lucid Air, even a minor rattle from the driver's side can be very noticeable and annoying.
- Poor Fit or Panel Gap: A damaged or improperly installed end cap may not sit flush with the surrounding dashboard and A-pillar trim. This results in an unsightly panel gap and can compromise its ability to block noise.
Known Issues, TSBs, and Recalls
There are no specific recalls or Technical Service Bulletins (TSBs) issued by Lucid or the NHTSA for the dashboard end cap itself. However, buyers of used parts should be aware of a related recall.
Related Recall: Instrument Panel Wiring Harness
In May 2022, Lucid recalled 1,117 model year 2022 Air vehicles for an improperly secured wiring harness connected to the main instrument panel. The harness could rub against the steering shaft, potentially causing the main displays to fail. Service for this recall may have required technicians to remove interior dash panels, including the driver's side end cap, to inspect and secure the harness. This increases the likelihood that vehicles, especially from the 2022 model year, may have had this panel removed. A panel that has been removed and reinstalled has a higher chance of having weakened or broken clips, making a thorough inspection of a used part essential.
Pro Tip: Forum discussions among early Lucid Air owners mention various interior squeaks and rattles as the cars break in. A loose or broken dash end cap is a potential source for such a noise right next to the driver's ear. Ensuring this panel is secure is a good first step in diagnosing a dash-area rattle.
Buying a Used 2022-2025 Lucid Air Dashboard End Cap
Due to the high cost and limited availability of new trim pieces from a direct-sales brand like Lucid, a recycled OEM part is an excellent option. Here’s what to look for to ensure you get a good one.
1. Inspect All Mounting Tabs and Clips
This is the most important step. The back of the panel has several plastic clips and tabs that snap into the dashboard structure. If even one of these is broken, the panel will not fit securely and will almost certainly rattle. Before buying, insist on seeing clear, high-resolution photos of the back of the part. Do not purchase a part with any broken or visibly stressed white plastic clips.
2. Verify Your Interior Trim Package
Lucid offers several interior themes, such as "Santa Cruz," "Mojave," and "Tahoe," each with unique colors and material finishes. The dashboard end cap must match your vehicle's specific interior. The two known part numbers, P11NAF0AS03 and P11NAFQAS03, likely correspond to different color or finish options. Because this information is not publicly available, the only way to guarantee a match is to buy a part from a donor vehicle with the exact same interior as yours. Ask the seller for the VIN of the donor car to help verify its original configuration if possible.
3. Check for Surface Damage
Carefully examine the front surface for scratches, scuffs, and any signs of chemical damage from harsh interior cleaners. Pay close attention to the edges and corners, which are most prone to damage. Since this part is directly in the driver's line of sight when entering the vehicle, even small blemishes can be noticeable.
Replacement Guide
Replacing the driver's side dashboard end cap is a straightforward task that most DIYers can complete in under 15 minutes.
Installation Difficulty: 1 out of 5
Tools Required:
- Plastic trim removal tool set
Step-by-Step Replacement
- Open the driver's door to gain access to the end of the dashboard.
- Gently insert a plastic pry tool into the seam between the end cap and the main dashboard. Start at the top or bottom edge.
- Carefully work the tool along the seam to release the plastic clips holding the panel in place. You will hear them pop as they release. Do not use a metal screwdriver, as it will scratch or gouge the soft-touch dashboard material.
- Once all clips are disengaged, the panel will come free.
- To install the new panel, align the clips on the back with the corresponding slots in the dashboard structure.
- Press firmly and evenly around the face of the panel until you hear and feel all the clips snap securely into place.
- Check for a flush, tight fit with no movement.
Cost Comparison
| Part Type | Estimated Cost |
|---|---|
| New OEM (from Lucid) | $75 - $200 (estimated, contact Lucid Service) |
| Used OEM (Recycled) | $40 - $100 |
| New Aftermarket | Not Available |
| Shop Labor for Installation | $75 - $150 (shop minimum, 0.5-1.0 hr) |
Frequently Asked Questions (FAQ)
Is this part for the driver's side or passenger's side?
This guide and the listed part numbers are for the LEFT (driver's side) dashboard end cap in the North American market.
How do I know which color or finish to buy?
You must match the part to your car's interior trim package (e.g., Santa Cruz, Tahoe, etc.). The safest method is to purchase a part from a donor vehicle that is advertised as having the same interior theme as your own car.
Can a broken dash end cap really cause a rattle?
Yes. In an extremely quiet EV, small vibrations from loose trim pieces become very audible. A dash end cap with broken clips will not be held tightly against the dashboard, allowing it to vibrate and create a buzzing or rattling sound, especially over rough pavement.
Do I need special tools to replace this part?
No special tools are required, but a set of plastic trim removal tools is highly recommended. Using metal tools like a screwdriver will almost certainly damage the soft-touch dashboard or the end cap itself.
Technical Specifications
OEM Part Numbers: P11NAF0AS03 P11NAFQAS03
Location: Driver Side (Left Hand). The specific difference between part numbers is unconfirmed but is believed to designate different interior color and/or material finishes.
We Have This Part in Stock
The information in this article is provided for general reference and educational purposes only. Vehicle specifications, procedures, and part compatibility can vary by production date, trim level, and region. Always consult your vehicle's factory service manual and verify part numbers before purchasing or performing repairs. Safety-critical components such as airbags, seat belts, and braking systems should be installed by a qualified professional.
- Lucid Air:
- 🛍️ Shop This Part
- Symptoms of a Bad or Damaged Dashboard End Cap
- Known Issues, TSBs, and Recalls
- Related Recall: Instrument Panel Wiring Harness
- Buying a Used 2022-2025 Lucid Air Dashboard End Cap
- 1. Inspect All Mounting Tabs and Clips
- 2. Verify Your Interior Trim Package
- 3. Check for Surface Damage
- Replacement Guide
- Step-by-Step Replacement
- Cost Comparison
- Frequently Asked Questions (FAQ)
- 🎟️ Get 5% Off